問題詳情
(A) As an old saying goes, “Don’t put off what you can do today until tomorrow.” Procrastination may __24__ us __24__ our precious time, and my brother happens to be a procrastinator in life. He tends to avoid his duties, and spends more time thinking up weak excuses for what __25__ than actually fulfilling them. What’s worse, he could hardly sit for a while and focus on one task at a time. Once, when working on the English project, he was constantly distracted by trivial matters, such as the noise outside the house or the stain on his shirt, and he ended up doing the project for three hours. Owing to his procrastination and his poor ability to organize things, when __26_, he could not think clearly and would muddle through his assignments. It goes without saying that the quality of his assignments certainly __27__ a lot to be desired. He, therefore, always finds himself __28__ to climb out of a pit of despair and frustration when one deadline after another flies by. If he doesn’t make up his mind to quit procrastination and be well-organized, he will be fated to be a loser for good.
24.
(A) steal…from
(B) convince…of
(C) replace…with
(D) rob…of
參考答案
答案:A[無官方正解]
難度:非常困難0
統計:A(6),B(0),C(0),D(0),E(0)
內容推薦
- Jacky studies English two hours a day. He is such a(an) _______ English learner that few can
- 工件實施氮化比實施滲碳處理之優點為(A)硬化層較厚(B)處理時間較短(C)變形少(D)處理溫度較低。
- 10有關滲碳處理的敘述那些正確?(A)表面硬度可達 HV1100(B)硬化層的厚度係指硬度大於 HV550 以上的厚度(C)氣體滲碳之氣體主要包含 CO 及 H2等氣體(D)滲碳處理後之
- 下列有關正常化主要目的之敘述那些正確(A)使晶粒微細化(B)改善機械性質(C)增加耐磨性(D)將鋼加熱至 AC3或Acm溫度以下 30~50℃保持適當時間後放冷於靜止的空氣中。
- 一、甲與 A 因事結仇,擬買通黑道分子將 A 殺害。某日甲持款前往 B 宅洽談殺 A 之事,因 B 甫經管訓完畢,不想再惹事,當場拒絕。甲再轉往 C 宅請託,獲 C 首肯後,復交予手槍一把。某夜 C
- 對工具鋼而言,下列有關淬火後之殘留沃斯田體之敘述那些正確(A)造成硬度不均不足(B)降低耐磨性(C)影響尺寸安定性(D)低溫回火可充分將其分解。
- 10高週波表面硬化處理,下列那些因素會使有效硬化深度提高(A)提高頻率(B)電阻係數較大的工件(C)磁導係數較高的工件(D)降低頻率。
- 常見表面滲透硬化熱處理方法有(A)滲碳(B)氮化(C)滲銅(D)滲硼。
- 複選題下列那些是回火的目的(A)提高耐磨耗性(B)消除內應力(C)提高韌性(D)組織安定化。
- 碳鋼退火後可觀察到下列那些組織(A)肥粒體(B)波來體(C)沃斯田體(D)麻田散體。
內容推薦
- 下列那些屬於火焰硬化之優點(A)可局部淬火(B)構造簡單(C)費用低(D)淬硬層容易控制。
- Jim’s family moved to another city, so he had to _________ to a new school, though he was re
- 下列那些熱處理可改善零件之耐磨耗性(A)正常化(B)退火(C)鋁合金時效處理(D)表面滲硼。7
- (A) will be done (B) should be done(C) should have been done (D) may have done
- 試在聯立不等式的條件下,求2x+y 的最大值為 。
- 氮化用鋼中常用的合金元素有(A)Cr(B)Al(C)Cu(D)Mo。
- Hundreds of thousands of _________ in Fukushima were evacuated after abnormal nuclear radiat
- 碳鋼球化處理後可以觀察到下列那些組織(A)肥粒體(B)沃斯田體(C)雪明碳體(D)變韌體。
- (A) rush (B) rushed (C) rushing (D) to rush
- 夏至時刻,臺灣下列哪一個都市的「白晝時間」最長? (A)臺北 (B)臺中 (C)嘉義 (D)高雄。
- 10 甲公司在民國 94 年 1 月 1 日及 12 月 31 日皆有$1,200,000 的普通股流通在外,在民國 93 年 6 月甲公司為了從前任子公司股東手中買下子公司,被要求在民國 95 年
- Hard work doesn’t _________ success. The destination is not the most important. What really
- 下列熱處理常用氣體中,那些屬於氧化性氣氛(A)H2(B)CO2(C)H2O(D)CO。
- (A) causes (B) makes (C) requires (D) leaves
- 若依據一般的地方時區的劃分,哪一組兩地所在時間「不」同? (A)(122°20E,12°N);(118°36E,24°S)(B)(7°E,20°S;7°W,20°S) (C)(177°E,40°
- 如圖所示,有一均勻磁場垂直進入紙面,在紙面上有四種導線組合,分別由兩條長度各為 L 和兩條長度各為 √2L的金屬線所組成,導線上的電流皆為 I ,其電流方向如箭頭所示,不考慮供應導線電流的迴路所受
- Compared with the magnificent power of the Nature, human beings are so __________. To avoid
- 鋼材經麻回火熱處理後可以觀察到那些組織(A)波來體(B)肥粒體(C)麻田散體(D)變韌體。
- (A) tried (B) trying (C) try (D) to try
- 12 甲公司在民國 94 年發生下列電腦軟體研發成本: 試問甲公司在民國 94 年 12 月 31 日的資產負債表上應被資本化攤銷的軟體成本為: (A)$54,000 (B)$57,000 (C)$5
- 11 甲公司在民國 93 年 9 月 1 日開立票據向銀行借款$1,350,000,票據利率為 12%,分三期平均清償本金,每期$450,000。同日銀行基本利率為 11%。在民國 94 年 9 月
- Don’t install the gas heater in the bathroom. The odorless gas leaking is almost ___________
- (B) Joe had been out the whole day trying to get a job, but his efforts proved fruitless. He had bee
- With some newcomers in our class this semester, we decided to go on a field trip to ________
- 那些氣體會使鋼加熱時發生脫碳(A)氧(B)氫(C)水蒸氣(D)甲烷。